Panasonic Plasma TVs have built-in fault diagnosing circuit. If any fault occurs with any circuit board inside, the loaded firmware will detect it and will give you its indication in the form or standby light blinks. From the number of blinks at one time, experienced service technicians can detect the faulty section [circuit board], without opening the TV. This will help technicians to detect and repair faulty section fast. Here are some hints about the number of blinks to Pansonic Plasma TVs. PANSONIC PLASMA TV: MODEL NO: X24 _ C2 _ U2 _ S2 _ G20 _ G25 _ VT20 & VT25 Switch ON the set by its main power ON/OFF switch at its front panel [not with remote control], and count the number of blinks occur before the set shuts down. 2 Blinks: 15V SOS D_BOARD / P-BOARD. 3 Blinks: 3.3V SOS D BOARD. 4 Blinks: POWER SOS P-BOARD. 5 Blinks 5V SOS D-BOARD. 6 Blinks DRIVER SOS 1 SC BOARD OR D-SC FPC...
LG 32PC51 Tv not working just green light blinking. Measurements of voltages on the lane showed the presence of 5 volts of standby mode, 3.3 and 1.8 volts were also present. the TV is due to the failure of the internal flash software VCT7993P.. For reading and writing, we used "POSTAL3". The connection was made to resistors R555 (SDA pin 84) and R556 (SCL pin 83). Problems during the firmware did not arise. By the time the process of reading and verification took about 15-20 minutes, the recording lasted as much. Flash software update VCT7993P was successful. Service manual and diagram LG 32PC51-ZB Flash firmware VCT7993P version V3.07 Firmware EEPROM 24C32 all link : LG_32PC51_VCTv3_07.rar: https://bit.ly/3ocCboU 24с32 EEPROM 32pc51.rar: https://bit.ly/2Tbkecj LG_32PC51_PP78C.rar : https://bit.ly/2TcAXvI thanks for watching, if you like my video subscribe and share.
Comments
Post a Comment